Will standard stationary glue work (Elmer’s, Kokuyo, or similar), or does something stronger need to be use? Additionally, I also need to glue in magnets into my 3D prints. What is the best kind of glue for this use case, or will any do fine?
They will only be used for a few prints, so I would like to avoid very large containers. Small bottles and syringes are ideal
edit: I will probably go with cyanoacrylate (CA) glue then. 3D Gloop has also been recommended, but is not sold by any local retailers and international shipping will take too long for the project I need to use it for. Could be a neat option for some people though. Thanks, everyone!
Somebody has also suggested acrylic/plastic cement for chemically joining plastic parts together, but in my experience with laser cut acrylic, it’s difficult to apply and can also affect the appearance of the print if you mess up. It also has a very short time window between application and fusing. I’m sure it works fine, and it will probably hold up better due to the plastics being chemically fused, but I will go with CA glue.
Interesting if that happens, but that seems to be caused by additives used by prusa in their filaments then, because from a chemical standpoint the crystalline structure of PLA is simply not dissolvable by acetone. It can cause swelling and delamination of layers, but not actually dissolve it (without additives that mess with the polymer chains)
Melty melty…
I’ll drop Ultrafuse PLA PRO1 in the jar when this one is gone. It does the same thing
I’m not actually seeing it dissolving at all though. It’s softening, sure, but it’s not dissolving like ABS does.
Sorry I was busy at work and I left it there.
It’s all gone. It just left a bunch of chunks behind - more than usual:
The acetone is black, and when it dries off, it leaves white plasticky powder on my hand.