I have an sv08 and it got hurt by static electricity so I had to replace the toolhead. But since I replaced it, the printer has been unable to print acceptably. I talked to sovol and replaced all the wiring between the toolhead+motors and mainboard but the attached pictures shows how it prints now. it does a lot better than it did, but its current status is strange. How come half of it is smooth and half is crazy? It would make sense it just x or just y direction was messed up, but it’s half of both…
Looks mechanical. Is it always that corner no matter the print? Check everything where the stress changes as the toolhead moves.
Your comment made me think it might be stripped teeth on belt(s) or gear(s)