I have an sv08 and it got hurt by static electricity so I had to replace the toolhead. But since I replaced it, the printer has been unable to print acceptably. I talked to sovol and replaced all the wiring between the toolhead+motors and mainboard but the attached pictures shows how it prints now. it does a lot better than it did, but its current status is strange. How come half of it is smooth and half is crazy? It would make sense it just x or just y direction was messed up, but it’s half of both…
From a 3d printing perspective, I have absolutely no idea.
But from the perspective of troubleshooting electronics, that’s a pretty awful situation: electrical shocks can cause all sorts of weird havoc with unpredictable behavior and unintuitive symptoms. If I was in your situation I would seriously consider cutting my losses short and replace ALL of the electronics and save myself from a major headache.
Source: I was tasked with fixing an MF/HF radio station that had been struck by lightning. And the ship it was on was only available around 0300 in the morning. I replaced so many components, including the ones that threw an error, but to no avail. I ended up replacing the entire station, antenna and tuner included.