While removing the extruder on my Creality Hi to clear a jam I damaged the wire that connects the extruder board to the print board and I have NO IDEA where to purchase a replacement wire.
It’s a 3pin wire roughly 9cm long with 2 male ends where 1 is about 2mm wide and other about 5mm wide.
MUCH appreciate any advice on where to shop and what search terms to use for locating a replacement, ideally located in the US.
UPDATE
After some trial and error did confirm the part number as 3103110734 Cutter Detector Wire and thanks to Creality forum thread found the wire and tip specs to be:
JST GH 1.25mm Pitch - locking type 3 Wire & SHR-03V-S-BSH 1.mm Pitch 3 Wire
The cables are 28: AWG, ~100mm Cable Length
Ended up just buying one off eBay for $15 shipped rather than attempt to make my own. Creality support did offer to sell one for $5 but with $30 shipping…
I think that’s the one! Mine even has the “D” printed on the white sleeve like that one has. Thank you!!
Creality Hi Series Filament/Cutter Sensor/X Limit Switch WiringSKU: 3103080144https://store.dremc.com.au/en-us/products/creality-hi-series-filament-sensor-wiring?variant=46843602665641
This is the only online store I’ve found so far that carries it. Will wait for support email to reply to see if they’ll supply it.
SEE UPDATE IN MAIN POST
Update: wire arrived today and it was NOT a match. The X Limit Switch wire has a white label with an X and while 1 end is correct the other is wrong. Creality support did eventually get back with me and said it was the cutter detection cable with SKU 3103110734 so guess I’m set back another 3 weeks ordering the other wire variations from DREMC. In hind sight I should have gone ahead and ordered 1 of each to be sure; oh well.