Superb

When did you design this? I remember printing a very similar phone stand years ago. I used it for a long time, it was great!

NixOS is great if you’re ready to learn Nix, which is an undertaking

After watching the video I’m not certain what it could be, but I’ve heard similar before from my printer so I’ll list them in order of sound similarity:

• My X belt wasn’t fully aligned in its track and it was rubbing on the side, which caused a similar clicked noise when any X move occurred.
• When there too much pressure in the hot end (from a clog, low temp, or too close to the bed, etc), I’ve seen the filament “kicking back” out of the extruder. Watch for a sudden backwards jerk of the filament.
• My X stepper motor made some terrible noises after tightening the associated belt. I’m not sure what’s causing it exactly, but I’m replacing the stepper soon.

I’ve just started my switch to PETG and I don’t think I’m going back!

No, the model does retain the original works in a lossy compression. This is evidenced by the fact that you can get a model to reproduce sections of its training data

Just spent 10 minutes researching MtGox, sounds like they were a pretty terrible bitcoin exchange and nowhere close to a bank.

Yeah but the value of my money doesn’t swing rapidly daily, and transactions process in seconds instead of minutes to hours. Oh and it’s actually accepted as a form of payment at most institutions.

Bitcoin, and all other cryptocurrencies, are securities at best and straight gambling at worst.

What are you talking about? Bitcoin started this, it’s was the first scam. It’s all bad.

Take your winnings and get the fuck out of crypto ASAP

This is possible! At least, I’ve seen it described in other people’s setups. Having the integrated GPU should help in this case.

If I remember correctly, you need to make sure the vm shuts down properly so that it shuts down the graphics card properly. Then you can unload the vfio-pci module and load the correct module for your card.

Two great resources are the subreddit (unfortunately) r/vfio and the arch wiki page: https://wiki.archlinux.org/title/PCI_passthrough_via_OVMF

I really agree. State sanctioned murder is unacceptable to me as well, but if they insist then let’s be humane about it.

In addition, the company’s surgeons plan to “sculpt the surface of the skull” to minimize the gap under the implant so that it sits flush with the normal contour of the skull. This, MacDougall said, should “minimize the gap under the implant” and “put it closer to the brain and eliminate some of the tension on the threads.”

Its wild that they didn’t do this the first time

My daily driver is an 8gb MacBook Air, I’m living pretty comfortably lol

I really like this! This might solve my problem of noticing a chore needs to be done but being too busy to take care of it in the moment and immediately forgetting

Less of a loophole, more of an intended feature

Oh wow, TIL! I guess I’m not surprised, consumer GPS is kneecapped at a lower accuracy for similar reasons

Do I need a background check to buy a CNC? Or a lathe?

Same here, except I use ear plugs as well as headphones