Then again what is the other Option? Not vote for either candidate like in 2024 and let Trump win?
I’m not a US citizen but I still act similar in my local elections - vote for the candidate that will do less evil when they’re in office, if there is no better option. And I gotta hand it to the DNC they’re really amazing at just cutting off their own legs. Because shooting themselves in the knee can’t describe this.
I mean you Gotta Hand it to “Ai” - it is very sophisticated, and Ressource intensive predicitive Text.
I did a similar thing with all my sheets - run over them with super high grit (400/800) sandpaper once or twice, clean with IPA and paper towels and since then I’ve never had any issues with prints not sticking
IMO that’s not the fault of Linux per se but of the manifacturers that only provide drivers/software for Windows and then let the community figure out the rest. The end result is the same just due to a different cause.
I’ve not user Klipper in a long while, but would it not suffice if Klipper knew 'Spool has 100m Filament left, print says it takes 110m, throw an error/require user confirmation to continue '?
Definitely! Mostly looking forward to see how/if other printers (especially Klipper) will support it
I’ve seen and used AI for snippets of code and it’s pretty decent at that.
With my colleagues I always compare it to a battery powered drill. It’s very powerful and can make shit a lot easier. But you’d not try to build furniture from scratch with only a battery powered drill.
You need the knowledge to use it - and also saws, screws, the proper bits for those screws and so on and so forth.
Not devoted to genocide - but rather when wanting better candidate (a real socialist candidate that does not support the war machine) but instead getting a sock puppet I’d rather try to have the sock puppet instead of letting worse people win.