The pressure is just set too high. There should be a valve under the sink that can be adjusted to reduce the flow

Other than ads, I think we’ve had a lot of “shorts” style content that people gravitated to in “the old days”. Things like AFV, whose line, QI, basically anything where it’s not a complete consistent show but a bunch of smaller capsulated segments.

The fact that this wasn’t done in a “sensible” (using that term loosely) manner, say, limiting wage for people who are dependants, or even people under 18, shows that this is just a way to further kneecap the younger generations.

For iOS (and I believe android), triggering an emergency call by hitting the lock button a bunch of times of times also disables faced/touchid

Were OG blue ticks grandfathered in?

Yeah I guess the “weird” wasn’t necessary

Children have such a weird aversion to wearing a helmet. I remember when I was in middle school school, other kids used to leave their helmets in a bush by their house so their parents wouldn’t find out and then pick them back up on the way home.

Technically a TLD is still a domain, just the top-level one.

Depends on the person. I feel like I peaked in my 20s but I’ve had my brother and few other people say they feel like their 30s were way better.

It was slop, but it was cheap slop.

The 180 probably would have been pre-tax

Oh you’re right, lol.

There is an X in the corner at least

Also take the filter out and wash it in the sink (unless yours is the filter-less kind)

I think the caption is fake but the picture isn’t. If you google “stretch Prius” there seem to be a bunch of photos of this thing going back like 15 years.

Edit: found an interview with the guy who makes these

95% of the time reader mode bypasses the paywall and this is one of those times

Find an stl of a disk and then overlap it with your part

You can try turning up the bed temp, lowering the z-offset to get the nozzle closer on the first layer, or increasing the first layer flow in your slicer. For me the purple glue sticks on a glass bed worked, but sounds like that’s not working for you for whatever reason.

Another trick I’ve seen people use is adding some circles to hard corners like that in the model that you can cut off later.

In the actual article it says “potential” new objects so probably at least more than 1

vi/vim