I have a extruder upgtade that required a 3x larger step/mm value :3 just a calibration quirk I forgot with the new firmware

This instruction helped me fix it, forgot that the extruder head had a custom direct where it needed a larger step value <3 brava

Low speed submersible unicorn

Yes

Yes I fully agree with this and also wish that this alternate reality was manifest, thank you for co-aligning on the matter-at-hand

Yes, this checks out, good job :3 appreciate your viewpoint

wonders what reality you’re living in where the president wasn’t boasting about Colbert’s late night show just in this last month getting cancelled