I’ve heard some reports that printing outer walls first has a positive effect on overhangs. I have it on in my slicer and it doesn’t seem to negatively effect anything.

I was just thinking the slashdot used to be a massive source of traffic across the internet.

And now it’s a sink. How times change.

I saw people chatting it up about how much better it eas. I finally installed and did the registration and signed in. Loaded my model, dealt with the wonky mouse controls, supppored, sliced, saved. Attempted to print, and it failed on the first layer. My first failure on that printer.

Went back to chutitubox and back to working prints.

Custer’s revenge would have been an acceptable answer as well.